Thanks to an influx of new computerized design tools, there are suddenly more custom ski makers and cheaper custom skisabout $1,300 for a pair of planks crafted to your physique and habits. Now you just need to know what to ask for.
how to ask for custom skisHow to ask for Custom Skis
Traditional gives you more control on groomers and ice, while reverse (upturned tips and tails) floats better in powder.
The amount of “rise” refers to how the tip is curved upward: shorter or low rise for sharper turns on hardpack, long or high rise for powder skiing.
Long skis increase stability in all conditions, and the added surface area keeps you on top of the soft stuff, but short skis are easier to handle and quicker to turn.
The depth the ski is cut from the nose to the waist, which determines its turning radius. Deep sidecut equals quick turns on the corduroy; shallow sidecut is for wide arcs on open terrain.
Narrow (<75mm) allows for rapid edge-to-edge transfergreat for mogulsand carving precision, but you'll sink in fresh snow. Wide (95mm) means you'll float but also work to bring 'em around.
Most shops use wood over foam to increase durability. Heavy woods, like ash and maple, make strong, stiff, and stable skis. Softer woods, like an ash-fir blend, are just as durable but make for a slightly lighter and snappier ski.
Determined by the thickness of the core and the stiffness of the structural layers. Racers want firm, but if you like bumps or tight chutes and powder, go soft.
Wagner Custom, Telluride, Colorado (wagnerskis.com) ScottyBob’s, Silverton, Colorado (scottybob.com) Igneous Skis, Jackson, Wyoming (igneousskis.com) Folsom Skis, Boulder, Colorado (folsomskis.com)
How to construct a bombproof winter campsite to keep you warm and comfortable
1. CLOSE THE DOOR!
Store your water bottles upside down (so the lids don’t freeze) in a small cupboard, using a snow block for a door.
2. BOOST YOUR BEDDING
Notch out a sleeping trench to keep you from rolling off your tarp, pad(s), and jacket. (The more layers you sleep on, the warmer you’ll be.)
RAISE THE ROOF Pitch a floorless tent over your sleeping area (you’re seeing only half the tent here, of course). Use a snow-filled stuffsack to support the center pole; otherwise it’ll sink.
“DEADMAN” YOUR TENT TO HOLD IT STEADY IN THE WIND
1. Dig a hole at the edge of the tent and tamp down the base.
2. Use parachute cord to extend your tent’s tie-downs.
3. Tie the cord to a stick using a three-to-one pulleyalso known as a trucker’s hitch.
4. Wedge the stick into the hole’s walls and bury it deep enough to pull the tent flush with snow level.
5. Bury the stick.
Bring extra pads to sit and stand on; you’ll stay much warmer.
6. RAMP IT
Build your one entrance into the kitchen, from the lee side of the site.
7. BURROW DOWN
Dig to roughly two-thirds your height below snow level, then carve out seats, a sleeping area, and a kitchen, adding lots of counters and shelves (might as well; you need the snow for a wall), then flatten and tamp down all surfaces.
8. WALL UP
Using the carved-out snow, build a wall on the windward side of your kitchen that reaches to head height.